Description
Finnish bathroom partition manufacturer HIETAKARI was founded in 1993 by Tuula Hietakari in Naantali, Finland. As HIETAKARI’s product assrtoment expands, the company’s specialists carefully nurture the idea that the range should always remain fashionable and of high quality. In 2018, the brand was awarded the Design from Finland label, which demonstrates its commitment to the best Nordic design values – high quality, responsibility, environmental friendliness and timeless design. The pillar of quality is based on production control and production management, which are fully computerised using proprietary software. The products are thoroughly tested in our factory test facilities, which far exceed CE quality standards.
L1 kraštinė: 139.8 cm.
Aukštis: 194.7 cm.
The product is manufactured of 6 mm thick tempered safety panel
The profiles mounted to the edges of the panel are manufactured of alluminium. The product is well-suited for a shower enclosure which has fixtures located on both sides and where the door has no space to open to the outside or inside. The doors slide behind the fixed walls, so that they would not require space for opening. Fixed walls and the doorway can be dimensioned so that the fixed walls support the fixtures and the doorway is of the width of the available space. The doors slide behind the fixed parts supported by the bearing wheels installed into the top edge of the door. The bottom parts of the doors move in the guide groove of the lower slide rail. A magnet seal keeps the door tightly closed during showering. Doors are equipped with long profile handles of the height of the entire panel.
The alcove fixture is attached to the wall of the building from the sides by means of wall mounted profiles. The alcove fixture can be installed either by a single lower slide rail of the width of the entire product or at least by a short lower slide rail of the width of the fixed screen whereby the doorway is an unobstructed entry. The product can be installed off the floor with the help of an adjustment legs, allowing the water to flow under the slide rail. Alternatively the water flow can be prevented by installing a seal (standard part) under the slide rail. Short and long lower slide rail, adjustment leg and the seal (standard part) are standard equipment.
