Description
Finnish bathroom partition manufacturer HIETAKARI was founded in 1993 by Tuula Hietakari in Naantali, Finland. As HIETAKARI’s product assrtoment expands, the company’s specialists carefully nurture the idea that the range should always remain fashionable and of high quality. In 2018, the brand was awarded the Design from Finland label, which demonstrates its commitment to the best Nordic design values – high quality, responsibility, environmental friendliness and timeless design. The pillar of quality is based on production control and production management, which are fully computerised using proprietary software. The products are thoroughly tested in our factory test facilities, which far exceed CE quality standards.
L1 side: 90.3 cm (A-40.5 cm; B-49.8 cm)
L2 side: 90.3 cm (A-40.5 cm; B-49.8 cm)
Height: 200 cm.
The product is manufactured of 8 mm thick tempered safety panel.
The fittings used in the product are manufactured of brass alloy. The shower enclosure consists of two fixed walls, withhinged doors attached. The product is well-suited for a shower corner on the outside of which are fixtures on both sides. The fixed parts can be dimensioned according to the depth of the fixtures so that when opened, the doors do not hit the fixtures. Doors can be dimensioned symmetrically or so that the doors are of different sizes. When the shower is not in use, the door can be turned in the direction of the building walls. Doors rotate 90 degrees in both directionsand are equipped with adjustable centring. The centring attempts to return the door back to the open and closed positions. A magnet seal keeps the door tightly closed during showering.
Fixed walls are attached to the wall of the building from the sides by means of wall mountedfittings and supported from the top edge by the braces installed in the corners as well as from the bottom edge by the fitting glued to the floor. Between the panels of the fixed walls and the floor will be a 25mm high gap. Between the panel and the floor may be installed seal (standard part)s , so that water will not be able to flow under the panels. Floor seals (standards equipment) can be installed at the bottom edges of the door panels, which will restrict the flow of water.
